Welcome to Zhejiang Guangming Plastics Machinery Co. Ltd !

+86-13429361674

CONTACT US

 

 

 

E-mail:sales@gmscrew.com   martin_bao@gmscrew.com

              gyscrew@163.com

QR CODE

 

 

 

Established In 1992

 

 

 

Copyright © 2018  Zhejiang Guangming Plastics Machinery Co., Ltd  All rights reserved  浙ICP备07001420号   Powered By: www.300.cn

NEWS

Latest Exhibition Information

Introduction to the correct cleaning method of Screw and Barrel for Plastic Sheet Machine

The manufacturer of Screw and Barrel for Plastic Sheet Machine tells you that when using an extruder or an injection molding machine, the barrel and screw are essential auxiliary accessories, and we know that these two accessories need to be cleaned frequently to maintain their performance Stability, how to clean it correctly? For friends who don’t know how to clean these two accessories, you can read the introduction below.

Screw and Barrel for Plastic Sheet Machine
1. Choose the correct cleaning agent
In today's developed economy, there are many cleaners on the market, and some cleaners are specially used to clean certain types of products, such as special cleaners for screws, but the prices of these cleaners are not cheap, and the cleaning effect is also good or bad. Not one. The manufacturer of Screw and Barrel for Plastic Sheet Machine tells you whether you need to use a professional cleaning agent. Customers can choose according to the condition of the machine barrel and screw. If resin is used as cleaning material, pay attention to helping customers save a lot of cost.
2. Use the correct cleaning method
When cleaning the screw, it is necessary to close the feeding port at the bottom of the hopper, and then reduce the screw speed to 15-25r/min, which needs to be maintained until the melt flow at the front of the die no longer flows.
The manufacturer of Screw and Barrel for Plastic Sheet Machine tells you that according to the processing technology, a special person is usually responsible for completing the cleaning work. When cleaning, you need to observe the screw speed and torque from the control panel, and you need to observe the pressure of the system. During the entire cleaning process, do not remove the die head, wait until the processed material is completely replaced with clean resin, then stop the machine and remove the die head, and then start the screw to allow the clean resin to flow out.
When cleaning the barrel, the heating temperature should be set at 200°C. After the barrel reaches this temperature, it will start cleaning.
3. Choose the right cleaning tool
When cleaning the barrel and screw, the cleaning materials and tools needed include goggles, barrel ruler, heat-resistant gloves, copper scraper, copper brush, cotton cloth, etc.
The manufacturer of Screw and Barrel for Plastic Sheet Machine reminds you to pay attention not to use very sharp steel tools when cleaning, so as not to scratch the surface of the screw and barrel.