How to control the temperature of Cold Feed Rubber Machine Screw and Barrel products

I believe that when operating the Cold Feed Rubber Machine Screw and Barrel, in order to normally produce rubber products, the temperature of the equipment needs to be effectively controlled. The accuracy of the temperature control directly affects the quality of the rubber products. So how to control the temperature of Cold Feed Rubber Machine Screw and Barrel products?

Before rubber products are produced, Cold Feed Rubber Machine Screw and Barrel products need to be preheated to a certain temperature before they can normally turn on the equipment and add rubber raw materials to the feeding system.
How is the temperature of Cold Feed Rubber Machine Screw and Barrel controlled? The answer is water. Generally, manufacturers will use a water temperature control mold temperature machine to increase the temperature of the water, and then use pressure to pass the conductor through the equipment circulating water circuit to achieve temperature control. When using Cold Feed Rubber Machine Screw and Barrel, the temperature control is divided into several sections. Each mold temperature machine controls a temperature control section. When the temperature is constant, the temperature of the water is transferred to the barrel screw. The device can achieve a temperature increase.
In the production process, the barrel and screw are continuously working with each other, so the temperature of the equipment will also increase under the operation of the barrel and screw.
However, if the temperature is too high, it is not conducive to the processing of rubber products. Therefore, it is necessary to control the temperature within a reasonable range to avoid continuous high temperature affecting the processing. Therefore, when the temperature of the equipment is too high, it needs to be cooled. Cooling by cooling water requires the use of a chiller.
The Cold Feed Rubber Machine Screw and Barrel must effectively control the temperature of the equipment during use. Too low or elevated temperature will affect the production results. I hope everyone has a general understanding of the temperature control of the Cold Feed Rubber Machine Screw and Barrel product equipment after reading the above introduction.