Detailed introduction
09
2018
-
08
Twin screw extruder transmission box maintenance matters needing attention
in usetwin screwIn the extruder, the reasonable maintenance of the machine is conducive to prolonging the service life of the machine. Therefore, the transmission box should be actively protected when using twin-screw extrusion. In order to protect the box, the following points must be done
1. Clean the box body and oil filter when changing the oil. After clarifying the lubricating oil used this time, load the clean lubricating oil on the box body again to clean the box body once, then release it, and then load it with new lubricating oil.
2. After 500 hours of first use, replace the lubricating oil once,
3. The transmission box of the twin-screw extruder is lubricated with original medium-pressure gear oil of brand No. 150.
4, normal operation oil level is not lower than the center line of the oil mark, lower than the center line, please supplement quickly
5. Change the oil every 3000 hours after use
6. The lubricating oil filter should be cleaned every month during the normal use of the transmission box of the twin-screw extruder, and the lubricating oil filter should be cleaned every week during the running-in period. Cleaning method, find the oil filter, open it, and take out the dirt.
Information recommendation
