The manufacturer of Screw and Barrel for Rubber Machine will show you: how to solve the problem of plugging the screw and barrel of the rubber extruder

The manufacturer of Screw and Barrel for Rubber Machine tells you that when the rubber extruder is extruding, due to the excessive amount of calcium carbonate, it is easy to cause the material to be blocked inside the barrel, and the screw and barrel of the rubber extruder cannot rotate. How to solve the situation?

The manufacturer of Screw and Barrel for Rubber Machine tells you that in general, most of the reasons that cause the plug of the screw and barrel of the rubber extruder are due to foreign objects inside, so the main solution is to clean up the foreign objects.
The way to clean up is to increase the temperature of the barrel so that the materials inside can melt. The Screw and Barrel for Rubber Machine manufacturer tells you to keep it warm for a period of time and start slowly. During this time, the temperature needs to be controlled to prevent the materials inside from being burnt. Lose.
The manufacturer of Screw and Barrel for Rubber Machine tells you that if you find that the screw of the rubber extruder barrel still cannot rotate normally after cleaning up the foreign objects, you need to consider whether there is a hard object stuck in the front part and see if the hard object can be pushed out. , The manufacturer of Screw and Barrel for Rubber Machine tells you to be careful not to use brute force to avoid the barrel being scrapped.
The manufacturer of Screw and Barrel for Rubber Machine tells you that if it still does not work, you need to replace the screw and barrel with a new one.